Leviton Structured Media Panels for Low Voltage
Please do not use Primex, On-Q or others – the hole patterns do not line up
Installation Examples
For projects with 400 watts or less
We recommend the PSE-4D and PS-51v96w products as shown in this video
In this video, we walk you through the steps required to wire our power distribution panels.
For projects from 400 to 700 watts:
We recommend the PSE-8D and the Meanwell UHP-350-55 product, adjusted down to 54v
For projects with more than 700 watts:
We recommend the PSE-8D and the Meanwell UHP-500-55 product, adjusted down to 54v
Photo is a 42 inch panel with 5 Sunricher SRP-2309-75CCT drivers for strip lights.
New Documentation Project
The top has the same outline - but each STP file does not include:
- 5 pin green connectors male/female
- DIN connectors
- AC connectors
- 8 pin connectors - male / female
- RJ45 connectors
- KF141V connectors
- KF246V connectors
A mix of these is used on each SML model. Step files for the connectors are available from Kaifeng to Cixi.
Then - these go into the Mospen boxes that also require installation instructions. But the push pins and base are the same in every case.
The system level marketing / installer documentation that is urgently needed will depict each of the SML models, from the aspect of installation or repair.
The models that need to be depicted are found on the ATX LED data sheets:
- 47605 and cover installation - definition of compatible sheet metal screws, depth concerns, alignment with 2x4 studs
- 51v96w from either Wentong or Novbo – they are interchangeable and any new GRE or other vendor will conform to the same outline
- PSE-4D
- PSE-8D
- ATX Hub
- GATS (double wide)
- SML-70CCT
- Shade controller (future)
- Meanwell installation in the Mospen 47605
- DF42 wiring
- DIN rail mounting (2 and 4 channel hub M2D)